Blowing OPC fuse on my B3030, I have checked all the switches, but I don't have a wiring diagram. Is their a way to jumper the OPC controller to test it? This it an interment problem. The wiring looks good, no bare wires. When a fuse blows and is replaced it may last a week or might blow in an hour. I have tried a 10 amp instead of the 5 amp, no difference. Help?
OPC Fuse Blows can"t find why!
- Thread starter yjjack
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
If it's truly intermittent then replace the fuse with a circuit breaker of the right size (5 amp), it will trip and reset it's self.
You ultimately will have to dig into it and find the problem!
Get the service manual.
You ultimately will have to dig into it and find the problem!
Get the service manual.