Mounting new loader

[ToddC]

I got my used westendorf ta26 for my m7950dt cab it came with JD3020 brackets, they look like they might fit, does any one have any picture of the ku3 mounting brackets so I see if I have them right.

I'm debating just buying the new mounts for the $1200, I don't want to mistakingly put stress on the frame by using the wrong mounts.

Any thoughts

 

[ToddC]

Anybody have any thoughts

 

[skeets]

Cant help you Bubba, just sometimes it takes a bit for the right guy to pick up on the post, I know you want to get it going but take a deep breath and relax

 

[Eric McCarthy]

If it were me I'd error on the side of caution and put the loader arms that are ment for it on the tractor and not half ass it. The JD backets may or my not work, you could break the mounts clean off and ruin your day. Or spend 1,200 and get whats proper to fit and do it the right way.

 

[ToddC]

That is what I was think just wanted to hear it from somebody else, I just ordered them.
Thanks for the help

 

[Tx Jim]

If loader came with a hyd control valve you will need to change it also. JD 3020 is closed-center and that valve could burst your tractors hyd pump.