Made some cheap easy light brackets today

[hobby farmer]

Made these today. 2" angle and 2" flat stock. $6 for a rubber sheet, and $10 in hardware. I was able to get a nut behind the lower non-threaded rops hole. Seems pretty secure

 

[DustyRusty]

Looks good, however, a machine of that caliber should have more lighting!

 

[hobby farmer]

Looks good, however, a machine of that caliber should have more lighting!

Thanks, it will eventually but we just bought it a couple weeks ago and only have 12 hours on it so far. Getting anything approved by the CFO is difficult right now

I mainly wanted a switch wired to a plug for my sprayer, and once that was, the electrical was 90% done for a set of cubes.

Just wish I could find a way to run electrical through the rops without drilling.

 

[GeoHorn]

Ingenious use of available locations…. but that location might prove too much glare/back-flash for regular nighttime use.

 

[Pawnee]

$16 eh?
You forgot labour for design and build time.

Nice work!

 

[country_hick]

$16 eh?
You forgot labour for design and build time.

Nice work!

When you have unskilled volunteer labor that cost is negligible.
I know, because my own unskilled volunteer labor has cost me almost nothing over the years.