Goodmorning gentleman here is the things that was asked about on my la1154 loader its on a m6060 2015 modelit was when they were changing over to the regen looked at one with no regen but by the time I got my cash together it was gone, so regen I went . So I bought this m6060 with loader la1154 new in 2015 with with box scrap and bush hog now the box scrap is normal size but the bush hog is some what large and heavy duty made for the job my last tractor long 680 that bush hog took a beating ,
Now the m6060 would not lift this bush hog up high enough to get it to a good clearance when not in use I took it back and was going to see if there was a way of getting it higher up when not in use a man that worked there asked me if he could help me and told him what my problem was he sad he could help he went to the back of the tractor and put his hand under passenge side I watched what he did he turned one of those two set screws I think they go to the up and down on the 3 point hitch he sad raise it so I did it went up higher I guess I told him I could still hear the pump running he sad lower it down a little and it will stop now this sounds a little bit off to me as I've looked back on it I think he was full of it I've not messed with it its still like he set it but I have replaced both joy stick cables one hose it was going to the bucket my son blue it out not got the hole dill out of that yet I have switched curl and dump lines then it dumped in both curl and dunp and did it fast but would not curl up so I switched them back took of the lines at the quick coupler to make sure they were getting fluid though them and they are I can take the cables lose from the spools at the valve body and pull or push them and ever thing works fine but the dump it's still the same way and by the way the floating bucket dose not work , but when I'm adjusting the cable last week it starts working somefirst time in a while.
Now though all this I was layer up for a while with a knee replacementand I'm still waiting on a shoulder replacement I saw this one day when I had to move my tractor over to my other building so I could park were it was . Now as far as the valve body I've been out of work for a while and got a while to go so I took out the spool for the curl and dump the white ring was broke so I ordered a new one and the black o ring to I put them in that's been around two years ago I've had this problem I guess 4 or 5 years and I've been looking and reading a lot about this I think I put the white ring and the black o ring in in the wrong order this has been a rough and long time I sure hope you gentleman can help thank you so much
Last edited by a moderator:
