L3901 electrical system

3901-2017

New member

Equipment
L3901
Dec 30, 2024
2
3
3
Texas
Good morning,

Tractor has p0606 p0303 e-93 and e94 code. The electrical system and panel do a lot of winding and flickering when the ignition is turned on. Goes completely blank when trying to turn the engine over then have to turn key off and start over to get the same results.

Have changed battery and cleaned up the battery connections and ground. Still doing the same thing.
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
33,899
9,117
113
Sandpoint, ID
Replace both battery cables.
It's more than likely a ground connection issue.
Also remove and inspect all the large slow blow fuses.
Have the battery load tested.
 
  • Like
Reactions: 1 user

eserv

Well-known member

Equipment
BX24, A1000 Kubota Generator
May 27, 2009
2,187
170
63
Hardisty, Alberta
Replace both battery cables.
It's more than likely a ground connection issue.
Also remove and inspect all the large slow blow fuses.
Have the battery load tested.
Pay particular attention to where the ground cable from the battery attaches to the frame. You can check this by attaching a booster cable from the Battery to a good ground on the frame and see if the problem goes away. The plate under the battery AND the frame must both have a good ground through that bolt
 
Last edited:
  • Like
Reactions: 1 users

3901-2017

New member

Equipment
L3901
Dec 30, 2024
2
3
3
Texas
Pay particular attention to where the ground cable from the battery attaches to the frame. You can check this by attaching a booster cable from the Battery to a good ground on the frame and see if the problem goes away. The plate under the battery AND the frame must both have a good ground through that bolt
Started with replacing ground cable today and it fired up. No issues yet, will follow up if things change.
 
  • Like
Reactions: 2 users