l3010 wont start

Horseshoezach

New member

Equipment
Kubota L3010
Sep 20, 2013
17
0
0
Martinsburg wv
hey all i have a L3010 gst and i wont start.a few weeks ago it was cranking slow so i went and got a new battery and replaced the terminal ends as well it started great then cranked fast. a week later hop on it and it just clicked i was pissed so just walked away. few days later hopped back on it it just clicked so i tried 3 or 4 times and it cranked real slow again but started. so the last 3 times it cranked real slow but started. i went to use it today and it clicked one time and now wont do anything. tried hooking jumper cables to it and still nothing used a multi meter says battery has 12v used test light checked ignition switch has current checked starter it has current now im lost anyone have any ideas please help
 

Bulldog

Well-known member

Equipment
M 9000 DTC, L 3000 DT
Mar 30, 2010
5,434
76
48
Rocky Face, Georgia
Have you checked the ground where it hooks to the frame?
Might take the cables off and clean everything real good again also.

Might have a bad battery. I put a new one in my trackhoe and it didn't last a week. Checked it with a load tester and it was bad.
A multi meter will tell you if it has power but a load tester will tell you if the battery is good or not.
 

Horseshoezach

New member

Equipment
Kubota L3010
Sep 20, 2013
17
0
0
Martinsburg wv
going to get a new ground cable today now i think iv traced the problem to the small wire on the starter it has no power with or with out the switch on i put a new ignition switch on it today then all the lights started working again but it would just make a clicking noise so i checked all the connections at the starter all were good theres a big square 40 amp fuse with a red wire going to the hot post on the starter and i tested it and its good but i unpluged the small black wire on the starter and cleaned it then put it back on and now nothing works. im thinking a relay maby ???????