Hi guys:
I'm used to dropping the 3 point arms(Ford 3000) outside the implement with lots of room to push them on to the pins. All implements were easy that way.
The RCR1260 is 32" pin end to pin end and the L2501 with R4 tires only allows the arms to go to 30.5". So I have to get one side on and then lever the cutter over hard to get the other side on.
Once on, I have to set the stabilizers for 1/2" clearance on each side which is pretty close.
I was thinking that 1" rear wheel spacers would solve this but my dealer think that's a bad idea for some unknown reason.
Is this a common problem?
What would you guys do?
Tire center to center is 45" like the book says.
I'm used to dropping the 3 point arms(Ford 3000) outside the implement with lots of room to push them on to the pins. All implements were easy that way.
The RCR1260 is 32" pin end to pin end and the L2501 with R4 tires only allows the arms to go to 30.5". So I have to get one side on and then lever the cutter over hard to get the other side on.
Once on, I have to set the stabilizers for 1/2" clearance on each side which is pretty close.
I was thinking that 1" rear wheel spacers would solve this but my dealer think that's a bad idea for some unknown reason.
Is this a common problem?
What would you guys do?
Tire center to center is 45" like the book says.