My L2500DT with LB400 loader has an issue when I try to power the bucket down. If I were to try to lift the front axle by tipping the bucket all the way forward and then power the arms don it will lift the front end until I let go of the joystick. I think I either have an issue with the valve or cylinders bleeding off. Any suggestions?
L2500DT Loader issues
- Thread starter Cstlerk
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Swap the lift lines for the curl lines and see if you get the same issue.
If you do then you have a blow internal seal in a cylinder, pull both and rebuild them.
If you do then you have a blow internal seal in a cylinder, pull both and rebuild them.