L245dt rear hydraulics
- Thread starter Eaglenest
- Start date
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
That is assuming that the loader is already powered by the tractor hydraulics or that you will use the same separate hydraulic pump as the FEL is using. But regardless of that it is easiest to pipe into the FEL valve for the rear remote valve.
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
See this thread for a discussion of the adapter block that might fit your tractor. It matched my L185.
post #1 shows the dimensions
B7100 Hydraulic block diverter (70060-00360 or 70070-00385)
Back in stock. CDN$40 plus actual shipping These are obsolete and no longer available. I have recently been contacted by a member asking if I will make him one of these after reading how I made mine. I know this comes up from time to time and would like to gauge the interest others might have...
www.orangetractortalks.com
No - it neans he can run the remotes off t
Show me a picture of your loader valve.
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
That is exactly what I said. I was just pointing out the two places where the flow could be originating from (and that it really doesn’t matter where the source is).