Hi all,
I have a L2000DT with 1300 hrs on it.
There is a lot of bearing/ gear noise when using it, even when hi/lo is in neutral.
I'm about to pull it down to inspect/replace bearings.
Is there any tips or tricks I should be aware of before I start?
And are they standard size bearings and seals in it?
it has had a collapsed side case bearing once, so had enough metal floating around to block the filter.
Thanks all.
Al (Qld Australia)
I have a L2000DT with 1300 hrs on it.
There is a lot of bearing/ gear noise when using it, even when hi/lo is in neutral.
I'm about to pull it down to inspect/replace bearings.
Is there any tips or tricks I should be aware of before I start?
And are they standard size bearings and seals in it?
it has had a collapsed side case bearing once, so had enough metal floating around to block the filter.
Thanks all.
Al (Qld Australia)