I have a kubota m9000 it's leaking antifreeze from a rubber hose behind the injection pump. This line is metal part of the the way with rubber hose on the ends. Is there a way to replace it without removing the injection pump?
Kubota m9000 coolant leak
- Thread starter kc9818
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Sounds like the line to the oil cooler, but that's a guess.
Post a picture of the leaking pipe/hose.
Post a picture of the leaking pipe/hose.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
That does look like an oIl filter cooler line.
It goes to the water pump housing.
And yes you'll have to remove the injection pump to get to all of it.
They hid a bolt (140) behind the pump.
It goes to the water pump housing.
And yes you'll have to remove the injection pump to get to all of it.
They hid a bolt (140) behind the pump.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Yes your right, Reread above I found the right setup that you have and edited the post to reflect.
OK that's what I was afraid of. I have all the nuts off the injection pump. I'm guessing I'm going to have to take the front cover off the engine and take it lose from the gear since it still seems to be held in doesn't slide out?
Just a few pictures and a follow up I had to take the hose off the water pump, remove the injection pump cover to get to the drive gear, and fuel bulb to get to the hose
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
I hope you marked all the Injection gears before removing it all as that's the timing.
Do you have the WSM (aka service manual) for it?
Do you have the WSM (aka service manual) for it?