L 35 tlb, there is a leak in the hydraulic delivery pipe (120 on schematic). I have it disconnected on both ends. Does anyone know how to get it out? I'm hoping not to have to completely disassemble the front end to pull it out & replace it. Thanks
hydraulic delivery pipe removal
- Thread starter Farm Ma
- Start date
120 on this diagram from KubotaUSA is a bracket. Is the line you're referring to on here?
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Yes! I've removed everything I can, I got better movement, but can't remove. Thinking about cutting it and using a rubber tube with clamps. Any thoughts?
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Ok that pipe is not delivery, it's suction.
So yes, you could just put a piece of hose over where it's leaking and make it work.
You need to remove the rear wheels, ROPS, rear fenders, seat, disconnect the steering hydraulics, and lift the deck assembly off the machine.