Wildfire
Active member
Equipment
Kubota L5740 HSTC3 and a Kubota ZG222Z, 2013 BX25D,Custom Toyota fork lift.
I think everyone now and then has to make some kind of tool. I know I have on many occasions. Yesterday I decided to repair a small weep I've had on my old forklift. The leak has been there sine i restored the old girl but before I could attempt to repair it I needed to make a 95mm wrench so here are the steps I went through to get'er done.
Steps included making a pattern. Transferring the pattern to some 3/8th plate and between the irionworker,plasma cutter and milling machine I got it done. I can see a use for a plasma table so I'll have to look into one of them next. Here's how it turned out.
Steps included making a pattern. Transferring the pattern to some 3/8th plate and between the irionworker,plasma cutter and milling machine I got it done. I can see a use for a plasma table so I'll have to look into one of them next. Here's how it turned out.
Attachments
-
87.5 KB Views: 688
-
57 KB Views: 737
-
67.4 KB Views: 735
-
95.7 KB Views: 713
-
81.2 KB Views: 727