Chevy truck guys

skeets

Well-known member

Equipment
BX 2360 /B2601
Oct 2, 2009
14,189
2,852
113
SW Pa
OK I need some info on the GM washer pump and how to replace it,,, its in an 04 Silverado sounds something is clicking when I push the switch but nada out the line, wipers come on so I have to figure that the fuse is ok so I put a little air back through the system and it bubbles up in the tank so the lines not clogged,,, how in the hell do I get the pump out of the tank with out tearing half the front end out ??
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
28,800
5,180
113
Sandpoint, ID
how in the hell do I get the pump out of the tank with out tearing half the front end out ??
Buy a new truck! HaHaHa
Yea that model takes a tad little work to get it out.
If I remember right I did mine by going at it from the bottom by pulling open the front of the wheel well.
 

skeets

Well-known member

Equipment
BX 2360 /B2601
Oct 2, 2009
14,189
2,852
113
SW Pa
Yeah that's kind of what I was thinking too,, jack her up take the wheel off and see if I can get to it like that,, it aint gona happen this week I don't think, 19 now 20 mph wind and -9 tonight
even in the garage,,,brrrrrrrrrrrrrrr
 

aeblank

Member
Jun 19, 2013
411
1
16
Cadillac, MI
It will freeze, but it does not expand, thus providing "protection" to minus whatever. And it boils at 150F.

Sent from my DROID RAZR using Tapatalk
 

olthumpa

Active member
Lifetime Member

Equipment
L275
May 25, 2011
1,501
2
38
Maine

aeblank

Member
Jun 19, 2013
411
1
16
Cadillac, MI
Where i used to work, someone mis-set the oven and we found out that dextron will freeze solid at -60C. Brrrrr.

Sent from my DROID RAZR using Tapatalk