Thanks for the replies. I was thinking of getting a wood chipper with hydraulic feed and hook the BH lines to that.
This is how the lines are hooked up and starts at the hydraulic block under the right foot area:
The top right port is to the implement, the bottom right is tank port from the implement, the left is outflow from the implement.
The top right hose goes to the loader valve. It is the fitting next to the pink stripe:
The fitting to the left in the above photo next to the green stripe is coming out of the power beyond port on the loader valve and it goes to the "P" port on the 3rd function valve:
The hose coming out of the "T" port of the 3rd function valve on the above photo heads to the BH.
It ends up as the female fitting in the below photo which shows the outlet hose from the BH with the male fitting looped into this female fitting with the backhoe removed.
The outlet hose with male fitting ends up back at the hydraulic block in the first photo. It is the hose on the left side of the block going to the from implement outlet block.
So with this setup will the 3 point be affected?