I am putting a 3PL assembly from a B8200 onto a B1600 The B8200 has an oil pressure adjustment screw on the hydraulic cylinder cover. I am wondering if I should change the cover for the original B1600 one which does not have the adjustment. The adjuster is seized and I would prefer not to have to dismantle.
Also, there is some sort of feedback control, via a rod, from the lift arm of the B8200 version to the hyd system. I hope to be able to avoid having to use that as it would take the place of the B1600 control levers which I hope to reuse (they fit the same outlet plate on both 3PL castings).
Finally there is some sort of strike plate attached to the rear of the well of the main tractor housing which I think limits the travel of one of the 3PL lever parts. This has a slightly different part No in the B1600 vs the B8200 lists and I am wondering if that is significant. (only last digit is different).
I would be grateful if anyone can comment on any of these questions.
Also, there is some sort of feedback control, via a rod, from the lift arm of the B8200 version to the hyd system. I hope to be able to avoid having to use that as it would take the place of the B1600 control levers which I hope to reuse (they fit the same outlet plate on both 3PL castings).
Finally there is some sort of strike plate attached to the rear of the well of the main tractor housing which I think limits the travel of one of the 3PL lever parts. This has a slightly different part No in the B1600 vs the B8200 lists and I am wondering if that is significant. (only last digit is different).
I would be grateful if anyone can comment on any of these questions.