Had a customer want to buy a rear half of a b7100d. Apparently his local dealer told him you could bolt the rear half of a 7100 onto a b6000 and resolve the non standard pto issue of the b6000. I've been looking through diagrams and comparing part numbers, I don't believe it will work but not sure. I'm also going to go out and compare them both in person but anyone have any knowledge of this? Thank you
B7100 rear half on a b6000
- Thread starter Mountainman
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
HUMMM, I looked and it looks like it might be possible?
If it's a 4wd it's going to be a challenge to get it to all hook up.
If it's a 4wd it's going to be a challenge to get it to all hook up.
Someone here had done it for b6000 with b7001 rear end
www.orangetractortalks.com
I've solved the anti-clock pto issue on my B6000, well for me anyway...
hi guys, I started another small project a few days ago whilst messing about with my B7100 gauge install, and i solved a long standing issue with my B6000, that pesky anti-clockwise pto rotation. I was thinking about how best to be able to utilize all my implements and be able to use them on...
www.orangetractortalks.com
Awesome. Thank you for that link.Someone here had done it for b6000 with b7001 rear end
I've solved the anti-clock pto issue on my B6000, well for me anyway...
hi guys, I started another small project a few days ago whilst messing about with my B7100 gauge install, and i solved a long standing issue with my B6000, that pesky anti-clockwise pto rotation. I was thinking about how best to be able to utilize all my implements and be able to use them on...