Looking for advice on dismounting my dozer blade. I've had no problem removing the frame and blade. The hoses from the cylinders to the control valve were quick disconnect fittings, no problems there.
My question involves the two hoses coming out of the aluminum block from the tractors hydraulic system that feed the dozer controller and cylinders. Can they just be individually plugged or must I somehow form a loop between them. Man are they close together in that block! I want to remove the mast and the control valve on the right side of the tractor.
I've acquired a front end loader with out a sub-frame and I hope to use my dozer sub-frame for both implements at different times of the year.
Any advice would be most appreciated.
Thank you,
Lucky in Kentucky
My question involves the two hoses coming out of the aluminum block from the tractors hydraulic system that feed the dozer controller and cylinders. Can they just be individually plugged or must I somehow form a loop between them. Man are they close together in that block! I want to remove the mast and the control valve on the right side of the tractor.
I've acquired a front end loader with out a sub-frame and I hope to use my dozer sub-frame for both implements at different times of the year.
Any advice would be most appreciated.
Thank you,
Lucky in Kentucky