B2400 3 point lift jerking

[Dunslandloy]

Hello all. Saturday I was burning brush and using my rear blade to push debris onto the pile. Everything was rosy. Put the tractor away that night. Sunday I decided to back blade the driveway after a snowstorm and the gremlins showed up. While blading, every time I would lift the blade and stop, the 3 point would start jerking/pulsing up and down. If I lowered the blade, no issues. Super UDT2 in reservoir full. Any ideas on what it could be...and how to go about repairing it? Thanks

1999 Kubota B2400HSD
868 hours
Kubota fluids and filters

 

[rentthis]

How far did you have to lower the 3point before the jerking stopped? Could it be adjusted to raise to high?

 

[Dunslandloy]

How far did you have to lower the 3point before the jerking stopped? Could it be adjusted to raise to high?

If I lower it then stop , the jerking continues. Any position other than resting on the ground this is occurring. Thanks

 

[rentthis]

try adjusting the knob under the seat between your knees. It may be adjusted to far in or out. Beyond that, I got nothin'.

 

[North Idaho Wolfman]

Get the WSM, you can get a copy off of Kubotabooks.com and adjust the feedback linkage.

 

[Dunslandloy]

try adjusting the knob under the seat between your knees. It may be adjusted to far in or out. Beyond that, I got nothin'.

Yea, already tried that. Thanks.

 

[Dunslandloy]

Get the WSM, you can get a copy off of Kubotabooks.com and adjust the feedback linkage.

Thanks Wolfman. I'll give it a shot.

 

[Dunslandloy]

Get the WSM, you can get a copy off of Kubotabooks.com and adjust the feedback linkage.

Wolfman, I found the procedure in the WSM. My question would be, I won't cause serious problems by adjusting the feedback rod will I? I don't want to cause anything to implode if I do. Thanks.