Hello all, new here and also as new as it gets to owning, and operating a tractor. I bought a B1750 HST at a great deal and am going to buy a box blade. This tractor already has a belly mower on it. My question: Can use the box blade (raise/lower) with the belly mower still on? Thanks!!
B1750 HST Implement usage
- Thread starter Hardtke
- Start date
Is that just setting the deck wheels to the highest position or is there another way to get it higher? Again, no idea what I'm doing here
Is there s knob on or near the floor with numbers on it? If its like my bx, it will have a setting called "TOP". This setting will allow you to use the rear lift fully without lowering the mower. One tip; you might have to raise your deck to the upper stop to turn the dial to TOP.
On mine you have to raise the deck higher than the current setting to move the dial at all.
Good luck with your new 1750,
DB
On mine you have to raise the deck higher than the current setting to move the dial at all.
Good luck with your new 1750,
DB
Last edited:
No, there's no kind of lever or anything with numbers on it. As soon as I can figure out how to up load pics I'll share em and see what yall think. I think mines a 1996
If your talking about the lever on the floor board No that is your rear diff lock. Use it when you want both rear tires locked together for better traction.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
On some of the older models there is a latching system that will hold the mower deck up and allow you to use the three point separately, I'm not sure on yours.
Look at the deck for a lever or a latch.
Look at the deck for a lever or a latch.
Yeah I'm not sure.. if it has one it sure hides well. It's defiantly an older model but runs great! I'd just hate to take the deck off every time I use the box because I'll use it alot and I found that the PTO is a pain to hook back up with one person
