mcmxi
Well-known member
Lifetime Member
Equipment
***Current*** M6060HDC, MX6000HSTC & GL7000 ***Sold*** MX6000HST & BX25TLB
I have three spring center rear remotes on my MX, two are used for the top-n-tilt and the third to run a ram on a Land Pride rear blade. I added the same set up to the new MX but am thinking that I might be better off with changing one to a spring center with float. My thought here is that I could float the ram that controls the tilt of a land leveler or rear blade when grading my driveway once the camber has been established. The top ram would be fixed since I see no benefit in floating that cylinder.
I'm assuming that a rear remote float valve can be used as a standard spring center valve but has the added functionality of having a float position, like an FEL.
I'm assuming that a rear remote float valve can be used as a standard spring center valve but has the added functionality of having a float position, like an FEL.