3point hitch/ BH issues

kcs

Active member

Equipment
Kubota B2650
Jan 9, 2021
149
28
28
Virginia
I have a B2650 with a BH 77 backhoe. A while back I post I was having problems with my 3 PH raising. I cleaned the quick connects and everything started working. It was slow but it works. Seemed to be delayed a few seconds. Today I was using the BH and could only do one function at a time with it. The fluids are full. And help would be appreciated. Thanks
 

beckmurph

Active member

Equipment
Kubota LX2610TLB/Woods finish mower/woods rotary cutter/
Aug 23, 2012
271
133
43
catlettsburg, ky
I have a B2650 with a BH 77 backhoe. A while back I post I was having problems with my 3 PH raising. I cleaned the quick connects and everything started working. It was slow but it works. Seemed to be delayed a few seconds. Today I was using the BH and could only do one function at a time with it. The fluids are full. And help would be appreciated. Thanks
Is your position control lever all the way down?
 

kubotafreak

Well-known member

Equipment
GRAND l6060, L3560, B6100, gr2100, tg 1860, g1800, g1900, g2160
Sep 20, 2018
1,019
372
83
Arkansas, US
Sounds like you may have a bad coupler. Does the loader work fine?
 

kcs

Active member

Equipment
Kubota B2650
Jan 9, 2021
149
28
28
Virginia
Yes the loader works fine. When I put the grappler on it works fine to
 

kubotafreak

Well-known member

Equipment
GRAND l6060, L3560, B6100, gr2100, tg 1860, g1800, g1900, g2160
Sep 20, 2018
1,019
372
83
Arkansas, US
You mind posting a picture of the coupler? Has the male end poppet been hammered on?
 

beckmurph

Active member

Equipment
Kubota LX2610TLB/Woods finish mower/woods rotary cutter/
Aug 23, 2012
271
133
43
catlettsburg, ky
Yes and a delay in the action
To me, that would indicate a hydraulic quick connect not fully seated.

Someone mentioned a stick hitting a coupling in answer to one of your posts.
I had a similar problem on a B2620.
Running rotary cutter in thick brush.
Stick half unlocked the fitting for the backhoe return line. Thought I had broken the hydraulics.
Found that fitting, reattached it and all worked well.
Hope you find your problem.
 

kcs

Active member

Equipment
Kubota B2650
Jan 9, 2021
149
28
28
Virginia
To me, that would indicate a hydraulic quick connect not fully seated.

Someone mentioned a stick hitting a coupling in answer to one of your posts.
I had a similar problem on a B2620.
Running rotary cutter in thick brush.
Stick half unlocked the fitting for the backhoe return line. Thought I had broken the hydraulics.
Found that fitting, reattached it and all worked well.
Hope you find your problem.
 

kcs

Active member

Equipment
Kubota B2650
Jan 9, 2021
149
28
28
Virginia
Yeah me too. I’ve check all the fittings. Maybe I’ll take them off clean them and reconnect. Thanks for all the help I appreciate it