Back story. Have pto generator near shed door. I like to park tractor inside instead of out in the snow or rain (whatever caused outage). However, also like breathing. I want to extend the exhaust maybe 10'-15' out the bottom of the garage door, but just crack garage door a foot or so.
Measured the exhaust tip is little less then 1.5".
Was thinking 1.5" black pipe and then wrap it with exhaust heat tape? To do 45 degree angles to the floor then straight out the garage door.
Only thoughts are if fumes can get pushed that far and if would cause back pressure or something I am not thinking of on the engine?
After writing this maybe just be smarter to install a rough exhaust fan...
Measured the exhaust tip is little less then 1.5".
Was thinking 1.5" black pipe and then wrap it with exhaust heat tape? To do 45 degree angles to the floor then straight out the garage door.
Only thoughts are if fumes can get pushed that far and if would cause back pressure or something I am not thinking of on the engine?
After writing this maybe just be smarter to install a rough exhaust fan...