Search results

Ok I’ll do some more digging and try to get ahold of TYM again. Do you think it’s possible that another port is the “PB” port and I’m tapped into the wrong one? Charles

I reinstalled the plug in port “T” and both loader and 3pt work great with no leaks. I was curious so I swapped Hose and put plug in “PB” and both loader and 3 pt work as they should that way as well. Am I safe to think it’s ok with just the two hoses hooked up? Charles

You are correct they are BSPP threads, I didn’t have a straight fitting JIC to BSPP and the ports are so close I couldn’t thread in both fittings. I lightly threaded the npt nipple in and went smooth I was careful not to strip threads or tighten too much. I can put old plug back in

Here’s the way I have it hooked up. I know it’s rigged right now but like I said before I will make it nice once I get it all figured out. Not great pictures but hope this helps. Thanks, Charles

Yes thanks, They were on it when I bought it, making sure everything works nice together then I will make it right. Charles

I hooked it up just like the drawing you sent. I will get pictures tomorrow and send them. Charles

Well good news is the loader works great! My 3 point lift no longer works, I swapped the “t” and “pb” hoses and quickly tested and no change. Any other ideas to make both work at the same time? Charles

I’ll give it a try. Thanks again! Charles

My tractor doesn’t use that block. The guy I bought it from had it on a Kubota b6100 I believe (he bought it used so not sure what it was on before that). He said he had it working but it was really slow because his pump GPM was too low. When I was testing it the way it is it will move plenty of...

I looked more into valve and still have a couple questions. ( sorry this should be this hard but I’m learning) Added are pictures. There are multiple ports not used with plugs in them The only ports labeled are marked in the pictures “t” and “p” but it’s unclear what ports go to those. Are there...

Thanks guys for the information! I will look into more tonight and see what’s going to require the least amount of modification. One other question, the loader valve does have a pressure relief around 2200psi but I don’t see a port for running a return line. It should have a return line correct...

Also does anyone know the GPM of the hydraulic pump on this tractor? Loader attachment requires 11GPM. Thanks! Charles

The old lines were capped off and my tractor doesn’t have power steering but I’ll cap them back up now I know I’m barking up the wrong tree! Could you offer some advice on how to do it correctly? Attached are pictures with the supply line from pump circled. From what I’m gathering is I need to...

Thanks for the reply! Attached are a couple pictures. There were two hardlines hooked up to the ports where the new hoses are hooked up now. Those ran to a solenoid assembly which controlled a small cylinder that raised and lowered one side of a 3 point attachment I believe. I ripped that all...

Hi all, this is my first time posting on the forum and am looking to see if anyone has any insight on this. I have a grey market L2202-m 2 wheel drive tractor that I modified and bolted a TYM X25 loader attachment too, I’m trying to tap into the tractor pump/manifold for a pressure line and a...