Search results

I finally finished the rebuild on my B6200D with the help of my neighbor. The hydraulics were also cleaned up and new o-rings installed. Life is good wheel barrel and shovel are not my first choice. I am going to restore a Kubota tiller in hopes to clear some dirt to grow a variety of berries...

how to check the ring and orings for wear to the piston under the seat

3 point hitch will not hold for very long

getting ready to put head on a b6200 engine do you locktite the bolts and how about some gasket adhesive on the headgasket? its been a education to say the least fixing this .pa-sf

what is the correct way to hook up springs that runs the d-850 engine . i have rebuilt the engine 0n a b6200d now we are putting it back together. the shop book has bad pictures to look at . i think i got the correct springs hooked they right way. just checking my skill set. THANKS PA-SF

how come the three timing marks on the front of tractor in the gearcase do not line up again while hand cranking the engine . i have not had any response to my thread yesterday from wolfman idaho hope you are ok thanks pa-sf

does any one know what the proper grit to use when putting new rings into a d-850 engine? i am going to use a flex hone to clean up the piston cylinders then replace all the bearings seals and gaskets

I had all 3 rebuilt new nozzles and pressure tested. I have opened the relief valve above fuel pump also put a new fuel filter and cleaned up rusty tank. I have noticed the kill knob will not allow me to be pull out so I can turn engine over so the fuel pump will get fuel to the injectors. All...