Search results

If you think the powers that be can't stay out of your fuel containers, wait till you need to replace a common two valve shower set. I wasted an hour Friday and much of the day today trying to find a quality replacement for a failed set. Yes, I can find some junk at the big box stores but...

Soon after buying my new Kubota I received a Customer Satisfaction Survey via email, now two years later I just received another. The first one would not allow me to complete and more attempts just locked me out, now the same thing again. I suspect that clicking on any button other than the...

The plastic cover in the center of the floor board, of my B2601, is mounted with two pins and two notches in the tin. These mounting points are at the rear with nothing but gravity holding the cover elsewhere. My problem is that the sharp bottom edge will catch in the edge of my shoe and often...

I bought a new 54" V30 Vernig grapple and I don't think it is designed quite right. While holding the grapple tines level and lowered to just touch the ground, the loaded arms dig even before the grapple tines. In this photo you will see that the tines can't be angled up slightly to keep them...

What is an acceptable rate of drop for loader buckets, backhoe buckets and outriggers? My new B2601 with a BH70 backhoe leaked down to where the backhoe bucket was dragging on the ground after driving just 200 yards. Messick's rebuilt the cylinder and I haven't had a chance to use it yet, but...

My new B2601 with loader and backhoe has been in the dealers possession for over two weeks to repair the backhoe. I told them in writing that the hoe drops down even with the engine running and that the cause is either the valve or the cylinder. Photos were provided. Today I received an email...

I bought a new B2601 with a BH70 backhoe, the first time I used it there seems to be an issue. I ran the machine for more than 2 hours at approximately 1800 RPM without shutting down. On two occasions as I moved slowly just 150 yards the backhoe was dragging in the dirt. Since the tractor was...

New BH70 backhoe with a BH1976 thumb will not use all 6 positions. When the thumb is raised completely it still partially blocks the last hole so the pin will not go in. With the thumb down one position, digging is reduced with the thumb resting on the soil. Apparently this thing is made...

When purchasing a new tractor, should there be warranty papers showing date of delivery supplied? I have nothing, and now see that my invoice is dated six weeks in arrears showing the date it was ordered.

I’m trying to determine if a 3,000 lb. quick attach forks system that weighs 364 lbs. is way too much for a B2601. There is one available in new condition, but it may be heavier than it should be. Any idea?

I have an enclosed Haulmark car trailer with interior that is 8' x 20' x 6' 6" high. The floor and ramp are both 3/4" plywood of a good grade, not the newer flake-board, but I have no good information about the ramp's interior construction. The tractor is a B2601 with loader and backhoe and it...