Search results

I recently went to sell my L1500, I backed up the the brush hog and attached it then pulled the tractor down to the driveway for the new owner to come pick it up. It ran great the night before went through all the gears tested PTO everytinhg working as it had for the last 2 years. When the buyer...

Hello All, I recently was given a agri four 48 inch rotary cutter. I need to know if I buy new PTO shaft does it have to be cut or can it be left long. The one i am looking at goes from 42.5 inches to 55.3 overall safe span. The one that is currenly there is actually about 4 inchs short and if...

Hello All, I have a L1500 that I need to get a PTO over run for but I am not sure how to measure it. It is a 6 spline but I dont know if I need to measure from spline to spline or just the shaft without the splines? Second thing I have seen them in a 1" 1/8 to 1" 1/8 and 1" 1/8 to 1"3/8 and...

Hello All, I have an L1500 and want to run a brush cutter and or maybe a small tiller but I am unsure how to measure the PTO for a over run clutch system. Also I am not sure on how the PTO actually works it has a knob that is marked hi and low but not sure what its for. I have just been using...

I am looking to replace my rice tires with turf tires what size rims do I need to buy to change over to the turf Tires. Also what if I find rims for the L175 is the bolt pattern the same as with the L1500 with the rice tries. If I go to the dealer and tell them I need rims for a L175 are they...

Ok folks, back to the brush cutter talk. I have a L1500 what type of rotary/brush cutter do you all recommend? I have a lot (3/4 acre) that has some small saplings(1/4 in to 2 inch),will my little tractor cut the mustard with the right cutter or do I need a bigger tractor? What type of cutter...

I have a parts manual for my L1500 but no maintenance manual. I need to change the hydraulic fluid and I need to check the level of the fluid. Also need to know the type of fluid to use same with the oil and filter. Its getting close to winter so I want to get it ready to store as it will not...