Search results

i have an l2800 kubota that was damaged by fire. is there anywhere i can purchase the end connector that plugs into the instrument cluster without having to by the whole wiring harness

Looking for parts for 2008 l2800 kubota. Need instrument panel, radiator, wiring, steering wheel etc. Need to replace due to fire damage

i have a l295 dt kubota and only have one forward gear in low and high. i removed the shifter cover and the plate underneath it to check and see if any thing was broken or loose. after a couple hours of trying to line every thing back back up, i finally got it put back together. it was really...

My l295dt will not shift into the higher low range gears or the higher high range gears . All i have is the lowest 2 gears in each and reverse . Is it possible a fork has slipped out of place or am i facing a broken fork ? Any tips for removing the top trans cover and lining everything back up...

what is this bolt and could i remove it and tap this opening as a hydraulic supply line . it is jocated on my rear 3 pt lift control

i just finished installing a new hydraulic pump and i have a pressure guage on the line . i did not have a guage before , i plumbed it in while trying to check for pressure on the old pump . i have noticed on the loader that i am seeing more pressure on the line when the bucket is going down...

vic i saw on one of the post where you had an aftermarket pump for an l245. do you have one for the l295 ? is it an upgraded model like the 245 . what would be the cost and how could i go about ordering it ?

what is the capacity of the hydraulic oil resevoir on an l295 dt . i drained the old fluid and need to refill

i put a pressure guage in the line today and had little or no pressure on the line . i tested it at the first joint straight out the pump before it reached any relief valves . if i revved the engine i got maybe 200 lbs of pressure max . should i assume its the pump or could damaged or poor...

are there any components inside fluid resevoir ( trans housing ) to affect pressure other than a suction screen filter or the pressure relief valve mounted outside under the seat . other than the possibility of air in the system , i am running out of ideas on external components

vic , i moved my loader lines and tapped in to the high pressure line per your video . after i did this i noticed the loader seemed to have more power but also was more of a drain on horse power when in operation .also the toggles for the loader wanted to stick in the wide open position when...

looking for a hood for or other front end shhet metal from an l295dt

finally a succesful conclusion to adding power steering to my l295dt . many thanks to this forum and the videos from service dept vic . this addition while a tad pricey is well worth the expense and effort. feel like i am driving a different tractor . anyone out there thinking of pursuing this...

i bought an aftermarket cylinder to add power steering to my tractor . i put a tee in my loader inlet and outlet connection and tied it in there . i have since received correspondence from the company that says the return line cant be shared with any other valves or implements . i dont know...