Search results

A branch got stuck under the tractor which resulted in losing all of the transmission fluid. The fluid was pouring out of the lower end of a clear vinyl hose. The hose was either cut by the branch or the branch pulled it off of whatever it is connected to. Can anyone tell me what the hose...

I've been have often forgotten to release my parking brake and as a result I'm unable to adjust the turnbuckle any further. Any suggestions? Thanks,

I'm find it very difficult to grease the u-joint that is next to the gearbox. There is not enough room inside of the u-joint to attach the grease gun coupler to the grease fitting. The only way that I can do it is to take the driveline off of the gearbox and then I'm able to open up the u-joint...

The amount of tilt is very difficult to control. The movement is so fast when the valve is activated that I have to tilt back and forth several times in order to get it where I want it. Does anyone know how to slow the movement down?

There are two hex nuts welded to the hinge. There is one on the side and another on the back. I'm going to attach a metal basket to the ROPs for carrying chains, tools, etc. and will bolt on the basket using these nuts. Does anyone know what diameter bolts would fit these nuts? My tractor is...

Does anyone have the dimensions of the Tractor Caddy that is sold by Tractor Mike?

This is a rookie question. My tractor is over one year old. When I look at the sight glass, it is a solid light yellow color all of the way up to the top of the glass. I'm wondering whether it is full or empty. What would an empty sight glass look like?

I have a top n tilt on my MX5200. it won't stay level while in use. Any suggestions?

Does anyone know the size of the zerk on the front axle support of a mx5200?

The spec sheet for this tractor says that the 3 pt. is both Cat.1 and Cat.2. How can it be both or is it an option when purchased?

The specs. for this tractor say that the 3 pt. is Cat. 1 and Cat. 2. How can it be both or is it either/or?

I'm doing an engine oil change on a MX5200. I would appreciate it if anyone could let me know what wrench size is needed for the drain plugs. Thanks

I have a new MX5200HST. The operators manual calls for both the "Transmission oil filter HST" and the "Hydraulic oil filter HST" to be changed at 50 hours. Is this an error or are there two separate filters for the hydraulic oil?