Search results

Looking to replace all o-rings on my '99 B2400 3 chamber injection pump. Have a small leak that's making a mess of the garage floor. Anybody have a procedure for doing this while maintaining fuel adjustments? Can the pump bushings be pulled for o-ring replacement without complete pump...

Hello all. I've got a 99 B2400 that's developed a drip, drip leak on the injector pump (see photo). I haven't tackled a diesel injection repair before and know that pressures can be dangerous so any and all input is welcome and appreciated.

Hello all. My B2400HSD recently had a complete clutch failure. I was mowing the yard and went into a turn and everything but the engine stopped. No PTO, forward or reverse, and there was a grinding noise that would only stop if I pushed the clutch in. I took it to my local dealer. They told me...

Trying to figure out the fuel line size running from the fuel filter assembly to the fuel pump. Didn't find anything in the manual. Thanks.

Every 2-3 mowings or a long brush cutting session, my clutch safety switch falls out of it's bracket. It never fails happening when I've shut down to refuel or take a break, then I try to start and nothing. Really bad location and bracket design. Once the switch is back in, the bottom nut...

I have a RCK60-24B mower on my B2400. I have to replace the gearbox seals due to a leaking bottom seal and was going to do the bearings as well. Is there only one bearing in each spindle? It looks like there is room for two bearings in the spindle housing but mine has only one,

Hello. I'm trying to find the correct thread pitch, size, and length of the bolts that go through the deck bracket into each side of the gearbox. There are 4 bolts in total. I believe they are two different sizes but not for sure. Thanks

Hello all. I've a 99 Kubota B2400HSD 4wd non bi-speed. Trying to spec the front wheel studs. Does anyone know the diameter / thread pitch on these? I want to see if our local NAPA carries the part. Thanks.

I was tired of my radiator burping hot coolant on the ground (and the garage floor), so I added this expansion tank from Advance Auto Parts. Problem solved. Sorry about the angle. The portrait/landscape went askew during upload.

I hope this can help others. I've been fighting a jerky 3 point on my B2400 for several months now.:confused: Thanks to Idaho Wolfman, I was able to settle it a bit by adjusting the feedback rod, but the jerk was still there. Long story short, I asked a tractor guy at work about the issue and...

Just replaced the seals on my RCK 60-24B gearbox. The belt pulley will not go back on fully. Key way lined up and starts down probably an 1/8 inch but will go no further. Any ideas on how to get pulley back on? Thanks

Hello all. Saturday I was burning brush and using my rear blade to push debris onto the pile. Everything was rosy. Put the tractor away that night. Sunday I decided to back blade the driveway after a snowstorm and the gremlins showed up. While blading, every time I would lift the blade and...

I used these blades for years on my Husqvarna GT2254 and thought they were the best cutting blades out there. Now I want to put a set on the RCK60-24B deck on my B2400. Question is, do the Gator blades require any spacers or special adapters on the Kubota decks? Thanks.