Search results

Brother in law next door found out the hard way that his block heater in no good. I checked it with a meter and element is open. While looking at it we found a second heater that was installed in a tee in the lower hose. Also not working. I looked up the tractor and the tee is factory but no...

I'm sure this has been talked about but couldn't locate the thread on this forum. Being that I'm in Canada I can only get UDT from Kubota. When I asked them about SUDT the dealer tells me its not sold in Canada due to the climate. What? So now Canada has no weather equivalent the the US. Not...

Went to use the tractor to snow blow the driveway and got a no start. Starting checking the obvious and then checked the safety switches. Traced it to the pto engagement switch. Has anyone else had there engagement lever seize? Sprayed it with Krown and was able to get it fully operational...

Winter has arrived in this part of Canada and I thought everything was ready to go. Put the subframe on for the front blower and discovered the hydraulic cylinder is leaking. Will call Kubota for a seal kit tomorrow. Never rebuilt a hydraulic cylinder but have redone tons of front shock. Doesn't...

Don't want to get into any discussion on how a 3 point backhoe is dangerous or possibly breaking tractor. This post is for anyone who has doubts about getting one. Family neighbor has a backhoe that I used today for a simple sump pump trench. We hooked it up to the b2601, he has a Kioti CK25, so...

Have a B2601 with the LA434 loader. While installing loader this weekend I noticed a lot of play in the upper loader boom. I'm assuming there should be very little slop if I move boom side to side with weight off pin. Asking before I remove loader to inspect. Always grease and just over 100...

Is it only the BX series that uses a cooling fan? How are the larger hst tractors doing it?

During the winter I have been using 10w30 diesel and have never had an issue. What I'm finding is that 10w30 is getting more difficult to find. Or am I missing something when it talks about oil class for my B2601. Manual states "not to use CJ-4" and a lot of the oils I've been looking at have a...

Brother in law has a new to him very used M4950. He recently developed a noticeable almost ticking sound. It ended up being a bad seal on the far left injector. Have the gasket and injector is cleaned up for re install. Does anyone know the torque spec for tightening the injector? Thanks.

This forum has been good at answering many of my Kubota questions and again asking for help. I sold my old bolens H1502 to a buddy and replaced it with a b2601. This is a question about adding too much conditioner to the diesel. Got a call today that he couldn't get the bolens started. I went...

First winter with a front mount blower and as I've done before didn't adjust the skis up high enough. Grab a little too much gravel from the driveway and now the chute is blasted clean, as in no paint left. Not a big deal. When I put it away for the season I'll pressure wash and repaint any...

I've been blowing snow for 20+ years with a 3 point blower. Never bothered to change chute angle and always got the job done. Now using a front mount blower due to neck issues. Yes they are more expensive but wow what a difference in blowing snow. So I read a lot of posts about adding a linear...

Did the 50 hr service today and was looking at the hydro filters. Both the new and old filters have no magnet. Is this the norm? I thought all the original tractor painted filters had a magnet on the hydro filter.:confused:

Looked at the wiring diagram and was considering adding a toggle switch to the hst safety circuit. If the circuit is open then no power can reach the starter solenoid. I know it won't stop everyone but maybe one. Also adding tractor to my house insurance. Any thoughts?

B2601 and BX2755HD problem solved Have my new blower hooked up and having an issue with hose connections. Currently have the up and down for the blower hooked up to the white and yellow ports. Works perfectly. Therefore the chute rotator has to be hooked up to blue and red. Chute only rotates...

Was checking tractor yesterday and seems I tore one of the inner boots. Does anyone know of where to get a replacement boot only. Looks like Kubota only sells them with the inner tie rod.

Purchased a new snow blower and sub frame for the b2601. Assembled everything as per the instructions and for the sub frame the instructions were excellent. Except for maybe the pivot bolt. The instructions say to torque the two bolts to 440 ft lbs. Really? Who has a torque wrench that goes to...

Need to add some extra lighting for next winter and was looking at installing inside the grill guard. This is primarily for seeing with a front mount blower. Any reason not to ?

I know its nothing special but the first time I looked I couldn't see it. Now it stands out.

Looking at purchasing a front blower for a b2601 but it's on a b2920. Will see if I can adapt it to work but curious if anyone has? Or can individual parts be purchased for a quick hitch?