Search results

When I rebuilt my L245DT steering the top of the shaft seemed loose coming out of the column and bushing. Before putting the steering wheel on I wrapped the column with electrical tape going up to the shaft , there I flipped the tape over and circled the shaft twice with the plastic on the...

Back when farmers tilled ground that was standard practice. Plow in the fall. Spring Disc and pull a drag. Plant when ground was worked up. Now spray in spring, no till planting. Spray again in summer if weeds are bad and if correct beans were planted. Beans harvested leaving 1 inch stems. No...

Never ever understood Kubota on this. In 1982 went to Kubota dealership and the lady in the parts department refused to order me a complete set for a L245DT that I wanted to repaint. Refused to do it because they all came individually. Guess they do not like selling labels.

Ford 8n worked on my L245dt. Pain to keep changing. Now use tiller on bigger tractor doing food plots. No low range on that tractor. Suppose Kubota used short arms to run up the lift capacity.

Your injectors maybe fine. My tractors and trucks all blow white when cranking in the cold and not firing. Just unburnt fuel. Power stroke Ford is the same as Kubota you need good glow plugs to get them to run. NO STARTING FLUID!!!!!

More stores opening everywhere. To many will not last. Prices have gone up to support this new growth. Liked the old business model ten years ago. Like Popeye says, "I am what I am".

L245DT I flipped the front tires on this tractor to fit on a trailer that had on middle, only two planks running front to back. Tractor had a front loader and crushed the front wheel bearings. My fault had been warned and went ahead and did the wrong thing. Now know how the front axle is put...

I need one to go with my drive over chainsaw.

asked and answered!

Kubota still stocks them in Columbus Ohio.

Switched to this from using anti-seze the silver stuff. Dry Molly cleaner to use.

You do not need to support Kubota. Many small tractors in the market. Google small tractor aftermarket front end loaders. Or more specific use your title. Cost of new will be the problem. Search for used

Get some brake cleaner and see if you can find out for sure where it is leaking. On giving it more thought just clean it up and put three tubes of corn head grease in. Run it if you still have some clean up to do. Any extra grease goes on the Pto shaft after pulling it apart. If setting out...

Use what you have. Load the rear tires and get chains for the rear. My tractor is near yours and I believe R1s require a different rim. My R1s are 35 years old and I am on my 3rd set of fronts. Bought my tractor used and could have bought a extra set of turfs and rims for 350.00. Never missed...

If you are going to leave your old Kubota outside you have to take the black cap off the center of steering wheel and cover every part with rtv silicon. Water runs right down the steering box and when full of water it freezes and you have junk yards just grinning. My L24DT has spent 35 years...

Bottom line when you are sitting on the ground make sure you have a 7 inch over lap, and both the front and back half are the same length. Get a tape measure and a black marker and make sure that everything looks right. You will have to cut both sides most times to end up with two equal lengths...

Bobcat the skidsteer dealer had cutting edge replacement in stock that fit my Kubota bucket perfect. My Kubota bucket had two 2inch wide 1/4'' strips running from front cutting bar to back of bucket. These were welded under the bottom of the bucket and needed replaced at the same time. Good for...

Rear wheels have several adjustments. You may need to move when running a planter or cultivator.

Rural King has jeans that were priced at 8.99. Bought a pair for painting. Fit like wrangler relax fit. Went back and bought 4 additional pairs. If I really wanted to be cool I would take my Carhart leather tag and have mom sew on the pocket. To old to be cool.

Should be 4 on top and 1 coming in on the left and 1 going out to the right. Kubota asked me for 1200 dollars for one on a old 1200 loader. Replaced seals for 6 dollars.