Search results

  1. R

    Drive shafts B7610

    I have this noise coming from under my feet when moving with a load. The upper shaft from the motor to transmission is sloppy on the spline at each end. I am thinking this is my noise. Have any of you had this issue? Can I get this shaft out without spliting the tractor? Thanks in advance for...
  2. R

    What oils do you use

    Thanks Eric, I knew there would be different views, but don't want to start a war.
  3. R

    What oils do you use

    I have a 2006 B7610 and have always just used the Kubota motor oil and transmission oil. Thinking about using Rottella for the motor. The big Q is thier transmission oil just AW-32 or will the tractor fluid from the local NAPA work. Getting cheap in my old age.:D
  4. R

    Noise under my feet

    Will do hodge. Plan on taking off the loader, pressure wash & deliver to Watkins tomorrow or monday. 1 thing I have learned so far is the 75 & 76 series tractors have a weak link in the transmission & do not stand up to heavy loads like carrying a full bucket of rock in high gear and the seals...
  5. R

    Noise under my feet

    After further review I think my luck is not so good. Took off back hoe & put on brush hog, same noise. This time I was able to trace it down better. Sounds like I have lost a bearing in the tail shaft. Time to take to the shop. Thanks for all your input.;)
  6. R

    Noise under my feet

    I am going to take the back hoe off again tonight & put on the brush hog. The sound starts as soon as I depress the forward pedal, I haven't payed enough attension to say if it does it when the reverse pedal is depressed. I am a little over full of oil in my trans, could this cause the noise? I...
  7. R

    Noise under my feet

    New to the site & need advise. Last week our tractor started making a crunching/grinding noise under my feet. Sounds like it's coming from inside the bell housing. I had it jacked up and listened to the bearings, all sounded good. Put it back on the ground and removed the back hoe, no noise...