Search results

Then I think you need to find out why no power is at that fuse holder OR if that fuse does not feeding anything that is not working. You should copy the wiring diagram and highlight the large RED and RED/WHITE wires. I can’t follow it that well but I think the red will feed battery power to...

Needs a nose to complete the face on the front end!

It sounds like you may not be getting power to the fuse block (if it has one) since most circuits should power through that. Did you check to see if you get 12v to there?

Will the bulb fit into the M16 hole? Then will it fit through the bore of the adapter (is the really important question)?

Not sure what you mean about the side of the fusible link ... But all the fusible link does is plug into a mating plug. Think of it this way, the wire that needs the fusible link in it is cut in two, the ends are the connected to the male plug (they are not connected to each other...

On my L185 they were M12 x 1.25 (extra fine)

My advice is to take it to a vet and see if it has a chip or tattoo to locate the owner. Probably not but I have returned a few strays through that method. If you don’t trust dogs don’t even think about keeping it. That is no good for you or the dog. There are no kill shelters or beagle...

Here is how it mounts on my L185

I am positive those threads are on this forum since it is the only tractor forum i follow. I recall that North Idaho Wolfman was involved in one of them but my search skills are poor on how to only search his posts and what words to look for. You may send him a private message and ask him to...

There have been cases where the lower arms get lifted up and the rod and piston separate in the large lift cylinder under the seat. I’ll look and see if I can locate a thread. That sounds like your problem to me. (Sorry could not locate the previous threads)

You may need to adjust the suspension so it doesn’t bottom out easily. I am not sure how your seat is supported but see if your manual talks about it

From other people’s post on similar parts the case is often the ground point. If you have two white wires I believe you will have a run coil and a stop coil. The WSM should have a trouble shooting section to help walk through testing.

If the fluid was bad then the pick up screen may be clogged and limiting the fluid flow into the pump. I am not even sure that that model has the screen but I believe most Kubotas have a fine mesh screen in the transmission sump at the pickup line entry. That is the only filter my old L185 has...

Another possibility is that the pump is working the fluid hard and heating it up too much at the high rpms. Do the hydraulic systems work fine at high rpms and slowly stop working? After they stop working at high RPMs do the immediately work well at low RPMs or does it take time (oil cools...

Kencove fencing has barbed wire online. I have never used it but other products from them were good products.

See if you can get it here, https://www.bare-co.com/files-pto2002-pto4

Here in Texas they build similar walls and them come back with smaller stones and fill in all the openings like chinking. Your walls look great

Yea I saw that and appreciate a good ribbing, especially since it is mostly true. I like perfection but can not achieve it often enough.

Thank you. Since there is not power at the gate, I am setting it up for solar only to see how it works out. If I have to I will run power out which opens up more options on the accessories that would work like magnetic locks. Being in Texas we have an abundance of sunshine to charge the battery.

You can get a new shield, I suggest you look at Bare Co for a replacement shield.