Search results

It was yesterday, but performed the 50-hour maintenance on my L2501 HST. Though it doesn***8217;t require it at 50 hours I changed the transmission fluid with SUDT-2. Per directions I did not operate the tractor immediately after changing the fluid and once I did start it I let it idle for a...

Re: Can you figure this one out? You melted a hole in the lower radiator hose. I see I missed the answer post.

Are you sure it was coolant (color and/or smell)? Could be water from condensation in the muffler from the last time it was ran. When you started up it blew the water out. Stopped dripping after it either ran out of water or muffler heated up and vaporized any remaining water.

I have a L2501 so can***8217;t speak directly to your loader. Based on my ops manual under the image of possible positions (lower left is blank) it states just below the image... NOTE: When the lever is at each corner position marked by asterisk (*) or lower left, boom and bucket cylinders work...

Roadworthy beat me to it. Since you mention that it***8217;s like the parking brake is on I will assume you***8217;ve checked that. My next guess as stated above is your brake may not be releasing.

As mentioned above if you have the operators manual the recommended pressure can be found. I took a permanent marker and wrote the psi next to each air valve of each wheel. I also wrote the torque foot pounds next to a bolt on each wheel so I don’t have to look up either when I am doing quick...

I’ll play. Took receipt of a new L2501 on 4/12/19 and it has 40.1 hours on it as of this past Saturday. Coming up on the 50-hour maintenance time.

I know this is an old thread but I have the same issue on my L2501 (CC backs off as I drive). I haven’t had a chance to get mine back to dealer. Where are these 3 tension bolts? Are they under the left floor board? Would tightening the locknut on the cruise spring (shown on page 3-S13 of...

This is only my second post I believe and I don***8217;t have the tractor you stated. But, per the operators manual (pg 48) there is a knob below the front of your seat that adjusts the speed the 3ph will drop. It could have been turned full open somehow and is not holding the pressure. I...

My first post here though following for a while. My 2501, purchased April 2019, has the plate.