Ok,good people, A just bought a new to me B2320. Love the tractor. Came with a FEL I would like to buy aMM mower deck for it.I am pretty versed with tractors. when a lower my 3pt I don't see anything under the center of the tractor that would raise and lower it. I hope I am not asking a dumb question. I came from a Simplicity Legacy XL diesel 4X4 thar I had for 15 years. Just wanted something a little bigger, and maybe easier to get parts for. any help would be appreciated. thanks.
Need alittle help please
- Thread starter leonard65
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Finding a RCK60-29B and all of thee linkage hardware for a 20 year old tractor is going to be quite a challenge!
The lift linkage uses the three point to lift it.
The lift linkage uses the three point to lift it.
Butch
Active member
Equipment
Kubota 2410, RC60-24B, FL1000- kubota hydrolic front snow blade- plug aerator
Good Luck on finding the subframe linkage. I have a B2410 of the same vintage and wanted to put a a loader on it.... could get the loader.... but finding a subframe was not going to happen.
Yeah, you know when I did some research on this tractor before I bought it, they claim the B2320 was made between 2008 and 2015. the add said 2017 which is how they are dated by the year they were sold. So I figured getting a MMM no problem, Wrong ! You guys think my rear PTO will spin a 60 inch deck ? or get a 48 inch deck? Thanks.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
You can run a 60" mower.
Send a PM to @Mountainman just in case he might have one that he could sell you.
Butch
Active member
Equipment
Kubota 2410, RC60-24B, FL1000- kubota hydrolic front snow blade- plug aerator
Should not be a problem at al for finish mowers. The issues usually arise if one starts using the finish mower to cut tall grass fields or worse yet as a brush hog....
In my book you don't "settle for a rear finish mower", it's the preferred mower Been using different rear mowers since 2002. Side note I never mow with the loader / frame attached. The weight of the deck means a lot with smaller tractors. My Ford 1210 with 13.5HP at the PTO runs a Caroni 60" rear finish mower just fine. HOWEVER, the same tractor will not run a 60" LandPride.
I did that experiment when I had the Ford and a Kubota B7500 at the same time. Both decks mowed well behind either tractor. The Kubota handled the weight of the LandPride (but it was the max) and handled the Caroni like it wasneven there. The Ford struggled with the LandPride deck even though it wears two front weights all the time.
Been using different rear mowers since 2002. Side note I never mow with the loader / frame attached. The weight of the deck means a lot with smaller tractors. My Ford 1210 with 13.5HP at the PTO runs a Caroni 60" rear finish mower just fine. HOWEVER, the same tractor will not run a 60" LandPride. I did that experiment when I had the Ford and a Kubota B7500 at the same time. Both decks mowed well behind either tractor. The Kubota handled the weight of the LandPride (but it was the max) and handled the Caroni like it wasneven there. The Ford struggled with the LandPride deck even though it wears two front weights all the time.