Recent content by yankeepac

My local Kubota dealer retired and closed up shop. I need to get oil for the engine, and hst, but dont have access to the kubota stuff any longer. Can anyone recommend alternatives from the Green man, or from Tractor supply, SouthernStates etc? L3200 HST

hoping I can get some advise about my leak, anyone know about this?

Ok all, Kept the cardboard down for a few days and found a drip. It is slowly dripping from the area where the 4wd/2wd lever attaches to. Looking at it looks like it is a little out of line, but not sure.

I paid the dealer to come out and do the 50 hour service, both engine oil and hydraulic. I assume they replaced all the filters, but unfortunatly I was not there when the actual service was done. I replaced the engine oil once before at approx 100 hours, and again last week. This is the...

I have 225 hours. (about 50 a season). I must admit I needed to have the problem before I realized I had a problem. The site window was always white, not sure if I ever saw fluid in it. I won't make that mistake again. putting cardboard down later, and will be keeping close eye on the levels.

Replaced the 2 hydraulic filters this weekend, for my L3200 ended up loosing approx 2-3 cups fluid, but went ok. The magnet had a fair amount of shavings attached, assume this is normal, but not sure how much is normal. I went to replace the fluid, and was suprised how much it took. Approx...

Replaced the 2 filters today and ended up loosing approx 2-3 cups fluid, but went ok. The magnet had a fair amount of shavings attached, assume this is normal, but not sure how much is normal. I went to replace the fluid, and was suprised how much it took. Approx 2.75 gallons. Does anyone...

Just stopped at the Kubota dealership here in town, got a gallon of super udt2, and the 2 filters. Glad I don't have to replace these very often. They recommended replacing the filters. any idea how much fluid I will loose when replacing the filters? Hope a gallon is enough.

I have noticed that my L3200 hst just started to feel sluggish when mowing. Also had episode where the bucket wouldn’t tilt up under a load (I was moving hay bales). The HST also seems to make more sound when operating. I have just shy of 250 hours on the tractor. Does this sound like low...

Thank you all for the suggestions and guidance. After multiple attempts to bleed the fuel injection tubes, and a lot of cranking of the starter I finally got the tractor started. Note to self, Never run out of diesel again. BTW I discovered the beauty of a Line wrench, my standard 17mm wrench...

The L3200 has a decompression knob that I am aware of. I always use a filtered funnel when fueling to keep it clean of dirt / water. gonna try and purge it all again tomorow, wish me luck

Unfortunately as I have already tried to to open the valve, and to bleed the injectors already, but can't get it to start.

Well I've opened up the fuel injector nuts, cranked the tractor and looks like fuel escaped from each. tightened them up again. I put the battery on jumper cables to the truck to top off the battery. put the glow plug on for full minute, Cranking gets it to almost started, but again just...

I haven't done the injectors, couldn't find any specifics in the manual. do I loosen them, then crank, or will the diesel flow by gravity. Really new at this type of thing.

Ran out of fuel this afternoon, didn't realize I was so close to out. Anyways I stopped the engine at the first sign of loss of power, and got the Fuel can and put 5 gallons in. Cannot get the thing started again. tried opening the fuel trap to make sure fuel was coming out. the L3200 doesn't...