Recent content by Witchgrass

Ok, thank you Wolfman.

Been doing some dirt work to start a new pond at the house. Tractor is a L 4400. I’m running a box blade with about 200 pounds of weight on it to cut a little better(too much weight?). With the box in the air, I’m noticing the main (largest) hydraulic line that runs to the FEL controls is...

Awesome! From the posts I’ve seen on here, that’s about 1/2 the price of what New ones are going for. That’s prob what I’ll do. Thanks Wolfman!

Had a limb hit and break off a piece of the lower plastic housing of the radiator. Looking to find a used one. Thanks,

I had a tree limb push and break off a small piece of the lower radiator housing. Anybody here successfully JB weld, or find another solution to weld the plastic back together? Tractor is a L 4400. Thanks, Craig

Thanks Wolfman! I’ll see if I can get it adjusted this weekend.

It was still assembled.

This is what it looks like now. Still leaks a little.

This was behind the blocking plate.

This is the area that holds the valve. It was epoxied, and painted over when I got the tractor. The epoxy eventually failed.

ATTACH]41662[/ATTACH] See the arrow? There is a chunk of the housing at that point that is missing. The draft control knob(I think that’s the correct term) was missing when I bought the tractor almost 2 years ago. The entire top needs to be replaced, along with the knob. I did get a estimate...

See the arrow? There is a chunk of the housing at that point that is missing. The draft control knob(I think that’s the correct term) was missing when I bought the tractor almost 2 years ago. The entire top needs to be replaced, along with the knob. I did get a estimate for that part. The...

Ok, I was wrong on what piece you were referring too. I’ll look at the tractor tomorrow and see what kind of adjustment there is. What is the WSM that Wolfman is referring to?

That’s another matter in itself. That valve that you are referring to was missing when I bought the tractor. Part of the housing that it’s encased in, was broken off, and epoxied over and painted. After using the tractor for a few hours, it started leaking, worse, and worse. It’s been welded...

I haven’t really checked it like that, but I can. It kinda seems like some kind of Valve is sticking. It won’t even lower correctly if the box blade is all the way up.