Recent content by Trev450r

I run Pat's on my B2601, the top link still works for everything I run on the 3PH.

My wood chipper with 2 saws and some tools is over 800lbs and my B2601 3 point lifts it no problem.

I run my Woodland Mills WC68 on my B2601, there is a in-feed speed control. If you ran it your bx you'd have to slow it down more, and not run to large of wood though it. Blade sharpness does make a difference in how the chipper preform too. The other thing is the WC68 is over 700lbs too, that...

My B2601 hit 132hrs so I changed the fuel filter, and installed my 3rd function kit(it came in a 5 gal pail and had no instructions from Kubota).

My dealership sends all there Kubotas out with a 60/40 mix, pretty much everything I own that needs coolant is 60/40 we do see -50'c.

I live in Northern Alberta Canada, a few days ago I had to plow snow. I don't run a cab on my B2601, but it does get parked inside a heated garage. I was -33'c outside, 10'c warm from the days before. On my B2601 I do block off the rad with some cardboard to help with keeping the engine temp up...

It was over 15% more when these machines are in the 50 to 60 fpt range 8 more Is quite a bit. "Horse power sells car, torque wins races"

The B2601 has more torque then the BX, my dealer I delt with had motor and pto hp and torque numbers they got with there dyno.

I'd go with the B2601, it can lift more little bigger tractor over all. The B2601 has more pto hp then the BX.

I use one of these on my 20l fuel cans for my B2601, helps to stop spills.

I know what your saying. On my B2601 there is the orange pto 540 speed marker on the tach. Before I changed the factory oil(most likely break-in oil) the tach would not go past the orange bar. After the oil change it will sit just under 3000 rpm. Oil does play a part in how a motor will run ie(I...

I was doing hours of loader work, and I just happen to grap one when I was off the tractor. Like I said I wasn't worried, I just noticed a difference in temp with the side panels off. I got my woodchipper is a few days ago, and running that for 3 hours straight, the temp gauge was not even at...

My B2601 has 70hrs so far, everything is good on it. When I was moving dirt it was wet heavy clay, and was taking heaping buckets maxing the hydraulics and the ground is fairly soft(this job should be done with a skid steer with tracks).The other thing I wasn't worried about the temp, when I...

I make sure the rad screen and rad clean all the time.

A few days ago I was moving lots of dirt on my acreage. It was +26'c(79f) outside, after a few hours the tractor was very warm, about half way on the temp gauge and the hydraulics were hot, couldn't hold my hand on the lift cylinders. The next day same temp and same running for a few hours but...