torch's latest activity
-
torch replied to the thread What’s with all the SPAM?.Mmmm. Spam and Poutine! Could be a hit. Maybe we could bake it in pasties (which I believe IS the correct plural of pasty, no matter how... -
torch replied to the thread B1750 dt. Hydraulic Control Block Pressure Relief.Bear in mind that the loader relief valve will limit what's available at the 3ph because it's first in the chain. If the loader relief...
-
torch replied to the thread How to switch boom for stick control.Ooops. Deleted duplicate post.
-
torch replied to the thread How to switch boom for stick control.Oooh, good point. There are even authoritative looking websites that have it backwards. EG...
-
torch replied to the thread Are all pallet forks created equal?.The max lift capacity of your machine is under 1,000lbs -- at the pins, inclusive of the attachment. Considerably less at the tips of...
-
torch replied to the thread How did he get injured?."After" takes up less headline space than "As a result of".
-
torch replied to the thread How to switch boom for stick control.Looking at the Canadian Kubota parts site, it appears there are two different port reliefs installed in the various outlets: "Port...
-
torch replied to the thread How to switch boom for stick control.My fear would be that whoever swapped things originally didn't know about the role of port reliefs and just swapped the hoses. (PS...
-
torch replied to the thread A little Machinist advice please.I don't think you can post a video here, or even a self-hosted video. I couldn't figure out how anyway. I think the only way is to host...
-
torch replied to the thread A little Machinist advice please.For those interested in playing at home, I sent AndyH a 3D printed pulley in carbon-fiber reinforced nylon: He installed it: and...
-
torch replied to the thread Possible project.The trailer's a Chevy. Is that combo even allowed? :D
-
torch replied to the thread A little Machinist advice please.Ok, I think we may have hit upon the underlying problem here. You know that's not a riding mower right? <lol>
-
torch replied to the thread A little Machinist advice please.I printed one off in cheap PLA as a proof of concept. The overhang of the upper half of the sheave is proving a bit challenging, so I've...
-
-
torch replied to the thread A little Machinist advice please.I should add that my concern over the hub thickness is related to where the pulley centerline ends up. The width of the pulley doesn't...
