Recent content by ToddC

No problem I got it figured out, hope your staying warm.

I took the battery to be tested at two places, thought the first place may have made a mistake and both said it passed to it home hooked it up and everything worked. Not sure what happened, but it works. Thanks for all of the help

Ok hoping it's the battery, the one I have is about 15 months old from TSC it's a 4dlt about $150 battery. where do you recommend getting the new battery from Thanks Todd

I didn't do anything to the battery but I did notice the negative was a little loose when I hooked up the charger. The battery is about a year old, I will let it trickle charge tonight and try tomorrow. I hope that is it.

I have a m7950dtc, I finally put a block heater it, I knocked out the freeze plug let the antifreeze leak out the hole, put the heater in and filled the antifreeze. Then started it topped of the antifreeze. I let it run for about 15-20 min, no leaks everything worked like normal. Closed...

I think I found a heat that might work, it made by zero start part #3100098 Anybody use these??

I pulled the frost plug but the block heater is to deep. Do I need a sleeve if so where do I get them from? I saw one for 32mm but not 35mm. The plug was 35mm M7950dtc Thanks Todd

Good memory wolfman, yes I tried to install a block heater but ended up pull The freeze plug but it had oil not coolant in it. I saw that some others had the same tractor and was hoping they could help and the dealer telling me to use a magnetic heat attached to the block. So I thought I would...

I just called my local deal and they said all they sell in the magnetic block/oil pan heaters. Do these work? I wanted to put a regular block heater in my M7950dt cab but can't seem to find where it goes. Do these work? thanks Todd

hi I also have a m7950dt cab where is your block heater installed on your tractor. I want one but can't tell where it goes. Thanks Todd

I still want a m7950 manual

I'll take the m7950 Thanks Todd

thanks for the help I went with the JD $75 per 5 gal vs $115 per 5 gal

It says it is a replacement for sudt

I have both JD and Kubota and only want to buy one hydrulic/transmission fluid, should I get low vis hy guard or sudt2 the JD dealer is closer and stocks it, and my kubota dealer sucks. I'm in MI so it gets cold, the JD is a hydro both have loaders. I know the is a orange site but thought I...