TheOldHokie's latest activity
-
TheOldHokie replied to the thread Blade lower on one side.Why do you have a new spindle and housing? Did this start when they were installed? Dan -
TheOldHokie reacted to edritchey's post in the thread M7060 - 3-Point Hitch control lever at the rear of tractor. with
Love.
I added that feature on my MX5400 Cab tractor it is something that really should be a standard feature on Cab Tractors in my opinion I... -
TheOldHokie replied to the thread M7060 - 3-Point Hitch control lever at the rear of tractor..When I was killing time at a local Kioti dealer that was a feature on several models I looked over. Seems like something a clever owner...
-
TheOldHokie replied to the thread Hydraulics are too fast, or Im too slow.Yes ypu can adjust flow rate. How you do it depends on your particular needs. What model tractor and loader? Is the bucket OK other...
-
TheOldHokie replied to the thread Air in hydraulic system.Read my earlier post. My guess is your pump is not priming for some reason. I would look hard at the new filter. Believe it or not but...
-
TheOldHokie replied to the thread Adding Draft Control to MX5400 with Rear Remotes.Having a cylinder in float should not affect draft control. My guess is the problem is physical interference which is a common issue...
-
TheOldHokie replied to the thread M6-141 50 Hr Service....15 GALLONS of Hydraulic oil? Don't Think So!.What the Hedgehog said. The flush is to remove break in wear metals and any manufacturing debris that may have been missed at the...
-
TheOldHokie replied to the thread Air in hydraulic system.Its not air in the system. Sounds like your pump isnt pumping. Let it run for a few minutes and cycle the hydraulic controls. If its...
-
TheOldHokie replied to the thread Question on a Kubota B2400 Loader Valve.Whatever its marked you should hsve 3 ports connected to the tractor - pressure in, pressure out, and tank return. None of the boom...
-
TheOldHokie reacted to WI_Hedgehog's post in the thread M6-141 50 Hr Service....15 GALLONS of Hydraulic oil? Don't Think So! with Like.
The mating surfaces of new gears wear in, shedding microscopic metal bits in the process, which cause significantly more wear than gears...
-
TheOldHokie replied to the thread Adding voltage gauge - questions.Inline fuse holders are nearly universal and dirt cheap. Dan
-
TheOldHokie replied to the thread Kubota L185 leaking hydraulic fluid between engine and transmission. HELP.That type of problem is often a bad transmission output shaft seal. Dan
-
TheOldHokie replied to the thread B7800 front axle ball bearing question.Gap fill is diametral clearance. 660 is a paste and not something I would use. 680 is what's on my shelf. Dan
-
TheOldHokie replied to the thread B7800 front axle ball bearing question.Calibration wont improve the comparitive measurement. I wanted absolute dimensions to try and determine whether bearung fit is supposed...
-
-
TheOldHokie reacted to NickAdams's post in the thread B2400 HST 4wd - Partially stripped bolt housing with Wow.
The Loctite 545 Automotive Pneumatic/Hydraulic Pipe Thread Sealant Purple failed immediately. Brought the tractor to Woodstock...
