TheOldHokie's latest activity
-
TheOldHokie replied to the thread bucket tilt.Your control valve is not the problem. You have a problem with the hydraulic connections. Dan -
TheOldHokie replied to the thread B7800 front axle ball bearing question.And that completes the circle. The OEM parts on the left and right sides are the same. They cannot be different fits unless the...
-
TheOldHokie replied to the thread B7800 front axle ball bearing question.How do you get one of each? Dan
-
TheOldHokie replied to the thread B7800 front axle ball bearing question.Nobody will ever accuse Kubota of consistency. That hub design has been in use for at least 25 years and all of the older manuals have...
-
TheOldHokie replied to the thread B7800 front axle ball bearing question.Yeah, I have that WSM and its an altogether different design with lots of very obvious sbap rings. But your post prompted me to check...
-
-
TheOldHokie replied to the thread M5040 3 point hitch.For the third time - what lever are you using to operate the 3pt? Dan
-
TheOldHokie replied to the thread 1640a loader float?.It cpuld mean that or it could nean move it and hold it. What I know is from the very git-go the detent on mine wa very light - just...
-
TheOldHokie replied to the thread 1640a loader float?.The factory manual covers all variants of the B1630 and B1640. It has a full section on "operating in float" but its silent on the...
-
TheOldHokie replied to the thread 1640a loader float?.I bought my tractor used with about 350 hours on ths clock but it was in excellent shape. I have the liader parts and operators manual...
-
TheOldHokie replied to the thread B7800 front axle ball bearing question.That was my first thought but that bearing is a 6304. The only 6305 I can find anywhere is #40 in the other diagram. The outer ring of...
-
-
TheOldHokie replied to the thread Front end loader control valve leaking.Kubota online parts shows the L1730 loader in the related units list for a L245. Does the diagram below look fami⁹liar? Look the...
-
-
TheOldHokie replied to the thread Hydraulics help : no pressure high rpm - normal at idle.I am not clear on the need for a separate return for the thumb but sounds good!!! Dan
-
TheOldHokie replied to the thread B7800 front axle ball bearing question.Looking at the parts diagram I would expect both bearings #40 abd #50 to be a press fit on the shaft as follows: Assemble seal to axle...
-
-
TheOldHokie replied to the thread B7800 front axle ball bearing question.
-
-
TheOldHokie replied to the thread Front end loader control valve leaking.I suggest you determine the model number and lookup the parts breakdown. Seals are not hard but taking detents containing lots of little...
