Recent content by Sawburner

Finished, works good, my driveway is in good shape and this will help me keep it that way. I just need to keep the crown and the water will run off and not down the driveway.

I got the blade at auctions a few years ago and was going to put in on a bucket on my 8N Ford, never did, sold it to buy the Kubota. Should work fine for a cutting edge.

Building a land plane to maintain my gravel drive way. Using steel I have on hand, I am having a couple plates made where I used to work. They can punch the holes in better than I can cut them out with the torch, too big to drill on my drill press.

We tried calling and no answer. I usually buy from ereplacementparts.com and they are good, OEM was cheaper, will not be using them again.

Any body order tool parts from OEM ? I ordered parts 7/15 got order confirmation, then nothing sent a email no response, they have chat on there web site got a auto reply every body is busy, hours later nothing. First time and last time ordering from them. Will be speaking with my bank to...

I bought a single axle dump trailer rated at 5842 GVWR trailer weighs 1354# gives you over 4488# of capacity, from Cross Country Mfg. built local to me and good quality. I use the dump more then I thought it will save a lot of work if you will be hauling dirt, gravel, fire wood, horse $hit among...

Here is a link to a better quality link belt but a lot more expensive. I have used this at work and they last a long time. McMaster and a cheaper version. McMaster

I have a L2501,and have a 5 foot rotory cutter, I cut foot high grass all the time in 4th low range running about 2,000 rpms, every fall I cut my field of golden rod (3 foot tall) mixed with grass, wild rose, briers and weeds that are 3 foot tall the same way, the tractor is not working hard...

Yup a couple days ago it was 70-80*, this is what I wake up to this morning.

We don't lose power for long or often, but we put a new furnace in last year ($17,000) we have hot water base board, it only takes once to make it worth it. If the storm that RI had was more west we would have been out of power with freezing temperatures. There is also peace of mind when a...

Propane, we already have two tanks (500 gal each) there for heat, our plumber just hook up to them.

Had a stand by generator installed. Generac 15KW 60amp, can’t run every thing in my shop but it will run the house and most of my shop. Power goes out for a few hours or days we can go about life normally for the most part.

I made a step today to make it easier to add fuel.

I have Diamondback on my Gladiator and love it. Takes about 15 minutes to take it off the few times I needed to. Completely water proof, only thing is it will freeze to the tail gate, wax the seal real good helps keep it from freezing.