Recent content by RacerX

Why don't you fire up the 2nd engine out of the chassis and check it before going thru the trouble to install it? Might save yourself some time. Sent from my SM-N960U using Tapatalk

I use a sharpie and write the date on filters, etc. Sometimes I put the source and invoice # for a radiator or such in case of warranty. Sent from my SM-N960U using Tapatalk

Not like it's an airplane that would fall out of the sky. Look it over well. Check hoses, belts, grease points, leaks, overall condition. Does it look maintained or abused? I've bought several and check these things. Start and run it, check all gears and implements for proper operation...

There's Wcctractor in Brenham. Good folks. Been around a good while. I haven't bought from them, just parts dept for my backhoe. Always been responsive and helpful. Maybe worth a shot. Sent from my SM-N960U using Tapatalk

Where at? Sent from my SM-N960U using Tapatalk

Thanks for the input all. Any ideas about getting the cylinder pivot pins out? Since this unit sat uncovered so long, the hoses and control valves needed servicing. I have pulled them off and replacing the hoses amd rebuilding the control valves. I'm dismantling the entire thing to sandblast...

It had cat1 pins on it from previous, I put cat 2 pins on it to match my John Deere 1130 diesel. It matches up nicely on the big John Deere. Where would I find a 3 point reinforcing kit? Any thoughts on where to source some parts? Sent from my LG-H918 using Tapatalk

I bought a Kubota M-1068 Backhoe from a local craigslist ad. It attaches via 3 point, pump is driven by tractor PTO. It has a label that says "Made for Kubota". several large Kubota letter sets with a gear symbol preceding the Kubota name. It doesn't have Japanese or any foreign marking...