PoTreeBoy's latest activity
-
PPoTreeBoy replied to the thread L3010 with LA482 loader, would like to put a 3rd function valve on, does anyone make just a simple mechanical valve?.That sounds like my technique with brush. The 'issue' with my setup is this: the valve section I added is the first in the stack. Since...
-
PPoTreeBoy replied to the thread Getting more lifting power for a LA211 loader.The kits come with a pressure gauge, for good reason. I wouldn't increase the pressure above the high spec.
-
PPoTreeBoy replied to the thread L3010 with LA482 loader, would like to put a 3rd function valve on, does anyone make just a simple mechanical valve?.Summit Surplus Center Tractor Supply has some, their port size and fitting selection is limited @TheOldHokie can guide you Are you sure...
-
PPoTreeBoy reacted to GrumpyFarmer's post in the thread What did you do to or on your Kubota today? with
Like.
Good day. Assuming the pile is moist, probably turn it every 3 days or so if wanting it to be hot/compost faster. (Ideally it should be... -
PPoTreeBoy replied to the thread Considering a L5030 HSTC.I'm calling low blow! 🐉
-
PPoTreeBoy reacted to whitetiger's post in the thread 2015 SVL90-2 Loud Hissing from Engine Compartment while running with Like.
Check the intake manifold where the AC bracket bolts onto it. You may have a broken manifold.
-
PPoTreeBoy replied to the thread Newly minted B2150HST owner....Sounds like you got the download from KubotaBooks. I think the only pages missing are the four electrical schematics. Sections M8 and S8...
-
PPoTreeBoy replied to the thread Considering a L5030 HSTC.
-
PPoTreeBoy replied to the thread Considering a L5030 HSTC.@D2Cat, i need that pole saw!
-
PPoTreeBoy replied to the thread Considering a L5030 HSTC.OP, if you buy it, take a thumb drive to the dealer and ask for Operator Manual and WorkShop Manual downloads.
-
PPoTreeBoy replied to the thread Daily Chuckle.When I lived in Houston, Marvin Zindler, the consumer advocate, did Friday health department restaurant reports. A Chinese restaurant...
-
PTo close the loop on this I have now run two trials of the pulley Torch did up which included "the hill". Pulley handled everything...
-
PPoTreeBoy reacted to billrigsby's post in the thread David Bradley Pull-Type Adjustable Blade, Adjustable 6’ Blade, Tires 7.60-15 with Like.
SOLD!
-
PPoTreeBoy replied to the thread Kubota L4310DT gear chunks in hydraulic filter?.Creeper gear?
-
PPoTreeBoy replied to the thread David Bradley Pull-Type Adjustable Blade, Adjustable 6’ Blade, Tires 7.60-15.I remember that project! https://www.orangetractortalks.com/forums/threads/david-bradley-pull-type-adjustable-blade.58432/