PoTreeBoy's latest activity
-
PI purchased my Kubota L3010 HST second hand last year. Came with a well used 5' brush hog and an RC-72A belly mower whose wear appeared...
-
PPoTreeBoy replied to the thread BH77 Hydraulic Cylinder Mess.To emphasize Dan's point, lower the 3ph position control below full up. If that fixes the problem, you need to adjust the feedback linkage.
-
PIf you are using the rake to spread/ level material the wheels would be nice. If you are raking brush/needles/ misc. you can adjust...
-
PPoTreeBoy replied to the thread L2195A Gear Oil change.Nvm
-
PPoTreeBoy replied to the thread 2004 Grand L5030 will not start.There's also a block with smaller fuses, probably under the dash. Check them also. Can you post the wiring diagram and maybe also the...
-
PPoTreeBoy replied to the thread Output gasket for Omni gearbox on landpride rcr1248.My shadetree 'friend' says put it together dry and see if it turns freely with a little backlash. If so, put a thin bead of oil...
-
PPoTreeBoy replied to the thread Daily Chuckle.Probly related, he may not want to admit it :cool:. I wouldn't blame him. Miss 🔀 Ark, hmmm, distant relative?
-
PPoTreeBoy replied to the thread I’m looking to add a backhoe.Google 'Kubota l650 backhoe specs'. For $8, you can have the brochure.
-
-
PPoTreeBoy replied to the thread where to buy cylinder repair kits.3. The outer seal is usually called a wiper. Its purpose is to wipe dirt, water etc. off the rod when it retracts to protect the real seal.
-
PPoTreeBoy replied to the thread Daily Chuckle.Resembles my ex-MIL.
-
PPoTreeBoy replied to the thread I’m looking to add a backhoe.There's a spec sheet on eBay. It was designed for the L185 et al. Should be ok if you reinforce the top bracket on your tractor, use it...
-
PPoTreeBoy replied to the thread where to buy cylinder repair kits.Good golly, $200 for the bucket seal kit! If you think you can, you can do it. If your shop's time is so precious, you can take it...
-
PPoTreeBoy replied to the thread Kubota Standard Bolt Grades.That's better than quarter turn too far, which I occasionally resort to.
-
PPoTreeBoy replied to the thread Lift arms on 2350DT stuttering with auger attachment.Does that L have draft control? I had a similar problem with my neighbor's JD until I figured out I was using the draft control o_O...
-
PPoTreeBoy replied to the thread 48 inch Kubota Deck that know one can identify - RC48RTG.The bottom one is spring loaded, apparently the top one is not.
