Recent content by Penguin

OOPS SORRY Im in Western Tennesee near Paris Tractor is just not for me

The one I have is 2 WD shifts fine

OOPS SORRY Im in Western Tennesee near Paris Tractor is just not for me

3 Point hitch has issues and all tires need replaced Starts and runs very well Just an old Kubota If in the market for one of these Let me know I will send pics Probably ask 1200 dollars it does run and function well after all

I pulled the hyd. pump and cleaned it up. Had some foreign debris I could not recognize but it was not that serious. I pushed air through the lines and and confirmed them clear. When I had the filter off I am pretty sure it had a bad seal and I think it was the wrong filter, but the old guy...

Thank you The journey continues but a new tractor is going to happen LoL

Well Completely removed the upper cap and then the control valve then inspected valve pistons and springs it all moves it all appears complete I hope I assembled correctly but not going to put top valve back on yet as I think I have a no pressure problem. I will as time allows ...

Anyone have any information on possible filters I can use to replace a hydraulic filter on a L2000 gray Kubota? And or any advice on how to find gray model parts like filters ? For that matter any parts advice ?

L2002 grey owner

Is a manual out there ANYWHERE ? What pump and where is it located that is being referred to earlier asking if it is primed? How can I verify?

I removed the top of the axle housing and I believe my control handle shaft was loosened in the past and was disconnected from valve control assembly Unfortunately, assembly was fairly easy and I could not discern anything wrong with the valves or block. So after reassembly the control...

Two questions 1. did you find your leak source ? I just like reading these articles and seeing results. 2. you said you had a manual Where did that come from ?

Wolfman Is he referring to the hand turned valve between the legs when sitting in the seat ?

Will certainly look for the same item Not familiar at all with the machine yet

Just got a 2002. Same issue. Guess cylinder has to be removed.