North Idaho Wolfman's latest activity
-
North Idaho Wolfman replied to the thread L4600 Help! Hydraulics.I would run it for a while, then change just the filter keep the fluid. Cut it open again and inspect. -
North Idaho Wolfman replied to the thread Offsetting rear blade ... should I grease it?.Nope you got it right, fluid film it is.
-
North Idaho Wolfman replied to the thread D902 3-Cyl PFR-KD Zexel Injection Pump Troubleshooting.Ok, You just continue on thinking you're all high and mighty and I'm a complete doof. Doesn't bother me in the least. PSA: You didn't...
-
North Idaho Wolfman replied to the thread Offsetting rear blade ... should I grease it?.I wasn't being sarcastic either, Just adding levity! :giggle:
-
So your fact checking my meme 🧐🧐🧐
-
And that my child is why I wear mirrored sunglasses just like the troopers!
-
North Idaho Wolfman replied to the thread L4600 Help! Hydraulics.I wouldn't be too concerned by that on a DT. If it was an HST then I'd worry a little.
-
North Idaho Wolfman replied to the thread Offsetting rear blade ... should I grease it?.NO PROBLEM. 🤪 :unsure: :ROFLMAO::ROFLMAO::ROFLMAO:
-
North Idaho Wolfman replied to the thread Kubota L4350 rear rim info.NO, incredibly unsafe! Did that make that point very obvious? You need a 16" rim
-
Thanks Wolfman! Semi-unrelated...is it safe to put a 9.5-16 tire on a 10-15 rim?
-
North Idaho Wolfman replied to the thread L225 l2000 broken steering box.#1 Reason for the hard steering is you have a loader on it. That tractor was never designed for that weight on the front end. I would be...
-
North Idaho Wolfman replied to the thread B7100 Project.D and DT are the same thing. And as far as the head goes, It just needs to be for a D750, nothing else matters. Before you get into...
-
North Idaho Wolfman replied to the thread Offsetting rear blade ... should I grease it?.NO GREASE! Dry fluid film. Or simple paste wax. both will let it slide easier, neither attracts dirt and both displace moisture.
-
North Idaho Wolfman replied to the thread Hydraulic Fitting questions.OK hear ya on loader relief valve location, I get that. I can tell which valve he has by the detents. It's a 4 position valve.
-
North Idaho Wolfman replied to the thread Hydraulic Fitting questions.I'll beg to differ with you on both counts. #1 On this model there is no pressure relief valve before the BH loop so deadheading the...
-
