Recent content by muddhogg

  1. M

    Wiring in Light on the back

    So your saying just cut the connector off and wire directly to it, correct?
  2. M

    Wiring in Light on the back

    I'm only using one of those small lights, so it should be fine. Is there a connector that I can wire to the light that will then plug into this connector under the tractor?
  3. M

    Wiring in Light on the back

    Talking about this connector -->
  4. M

    Wiring in Light on the back

    Thanks! What kind of connector do I need? It looks like there is a connection there just waiting to be plugged in.
  5. M

    Wiring in Light on the back

    I know 0 about wiring in lights. I purchased an LED light off of Amazon, this one. And I also purchased this wiring kit. I'm only mounting one of the lights on the back. I see there are some connection under the left fender (L2501dt). Where do I even begin? I was hoping I could just make a...
  6. M

    L2501 3PH stabilizer problem

    Just took a pic for you, hope it helps. Bad quality in the dark.
  7. kubota_3pt.png

    kubota_3pt.png

  8. M

    Grease selection

    Thanks for the technical info B737! I did some research on BobisTheOilGuy and it seems that the Schaeffers 238 was a good recommendation for the FEL.
  9. M

    Grease selection

    Changed my mind, think I'm going to go with Schaeffer Manufacturing Co. 02382-029S Ultra Supreme Grease, NLGI #2
  10. M

    Grease selection

    Thanks guys, I saw in the manual that the FEL suggests moly.
  11. M

    Grease selection

    I think I've finally got it narrowed down to which grease to use, just wanted to double check I'll be using the right kind on the right parts. Valvoline Moly-Fortified Gray Full Synthetic - for the FEL (loader) and Lucas Oil 10005 Red 'N' Tacky - for the tractor Look good? Tractor is an...
  12. M

    Break in period

    I have never broken in a tractor, vehicle, atv, utv, etc… I buy it, then I use it to do what I need.
  13. M

    Laser cut L2501 floor mats

    Got mine in and put them on, fit like a glove. Highly recommended!
  14. M

    L2501 RPMs

    I did not know that.
  15. M

    L2501 RPMs

    Yeah I’ve been doin all my work around the 540 PTO mark. Was just watching a dude on youtube doing work at idle and was wondering why in the world he was doing that.